Asus SL6000 Setup Instructions page 57

Solwise Asus SL6000 ADSL Ethernet Router User's Guide
Start IP
End IP
Remote Secure Group
This option allows you to set the remote (destination) secure network to which this rule should apply. This
option allows you to apply this rule inclusively on all computers in the external network. Use the "Type"
drop-down list to select one of the following:
IP Address
Subnet
IP Range
Remote Secure Gateway
Key Management
Two modes are supported: pre-shared key and manual key.
Preshared Key
IKE Proposal Settings
Preshared Key
Encryption / Authentication
Life Time
IPSec Proposal Settings
fields become available for entry when this option
is selected:
Enter the starting IP address of the range.
Enter the ending IP address of the range.
Select any of these and enter details as described
in the Local Secure Group above.
Enter the appropriate IP address for the remote
secure gateway.
Select Preshared Key from the Key Management
drop-down list.
Enter the shared secret (this should match the
secret key at the other end).
Select the IKE authentication and encryption from
the drop-down list.
All
3DES & SHA1-DH2
3DES & MD5-DH2
DES & SHA1-DH2
DES & MD5-DH2
3DES & SHA1-DH1
DES & MD5-DH1
DES & SHA1-DH1
DES & MD5-DH1
3DES & SHA1-DH5
3DES & MD5-DH5
DES & SHA1-DH5
DES & MD5-DH5
Note: It is recommended that you choose All to
have all the IKE proposals associated with the
current tunnel and allow IKE to automatically
select one (among the set of IKE proposals) to
communicate with its peer. However, if a specific
proposal is required, then it can be chosen from
the list.
Enter the IKE security association life time in
seconds, minutes, hours or days.
Chapter 6. Configuring VPN
57