Asus SL6000 Setup Instructions page 71

Solwise Asus SL6000 ADSL Ethernet Router User's Guide
to carry traffic on a best-effort basis, unless Traffic Parameters have been explicitly specified
•
The dynamic and static routing on the Broadband Gateway
Configuration Parameters
Channel: Select the ATM Interface that is to be configured or viewed
1.
2. VPI and VCI: These settings are used to specify the Virtual Path Identifier (VPI) and Virtual
Channel Identifier (VCI) that is used for connecting the Broadband Gateway to the ISP's ATM
Switch using the specified ATM Interface.
VPI: Enter the VPI of the ATM Connection to the ISP's ATM Switch
o
VCI: Enter the VCI of the ATM Connection to the ISP's ATM Switch
o
3. Select the option VC Mux to carry your Internet Service without encapsulation over the ATM
Interface, else select the option LLC - contact your ISP for details
4. Default Gateway: Select this channel as default gateway of the Broadband Gateway
5. RIP Tx/Rx: Select send/accept routing updates on the channel via RIPv1 or RIPv2, this
setting will only be effective if RIP is enabled in Global Setting page
6. QoS: These settings are used to specify the service category and traffic parameters that are
to be applied for traffic over the specified ATM interface. Choose one of the following options
depending on your traffic requirements.
None: The traffic carried over this interface will be on a best effort basis without any
o
guarantee of quality-of-service
CBR: The quality-of-service applied to traffic over this interface is that applied to
o
Constant-Bit-Rate (CBR) traffic.
VBR-rt: The quality-of-service applied to traffic over this interface is that applied to
o
Real-Time-Variable-Bit-Rate (VBR-rt) traffic.
VBR-nrt: The quality-of-service applied to traffic over this interface is that applied to
o
Non-Real-Time-Variable-Bit-Rate (VBR-nrt) traffic.
UBR: The quality-of-service applied to traffic over this interface is that applied to
o
Unspecified-Bit-Rate (UBR) traffic
carrying user traffic, can be carried over this interface. The value specified is in cells per second
(Each ATM cell is 424 bits)
variation in time between the processing of two consecutive ATM cells carrying user traffic, over
this interface. The value specified is in microseconds
carrying user traffic, can be carried over this interface. The value specified is in cells per second
(Each ATM cell is 424 bits)
unprocessed cells that can be buffered over this interface, before they are discarded. The value
PCR: The Peak-Cell-Rate (PCR) is the maximum rate at which ATM cells
CDVT: The Cell-Delay-Variation-Tolerance (CDVT) is the maximum
SCR: The Sustainable-Cell-Rate (SCR) is the average rate at which cells
MBS: The Maximum Burst Size (MBS) is the maximum number of
Chapter 7. The Configuration Pages in more detail
71