Command Line Interface Mode - Asus SL6000 Setup Instructions

Chapter 8. Command Line Interface mode

8 Command Line Interface mode

Login : admin
Password :
admin logged in
106
Solwise Asus SL6000 ADSL Ethernet Router User's Guide
Although the majority of the most common set-up options can be
done via the web interfaces you can also configure the unit via the
Command Line Interface (CLI) mode.
To run the CLI commands you can access the SL6000 using telnet
modem or via serial port. By default setting, the Router is configured
to communicate at a baud rate of 9600. Any standard terminal that
supports baud rate of 9600 can be connected to the Router's
console port. Please configure your serial port as:
BPS :9600
Data bits
Parity :None
Stop Bits
Flow Control :None
When in CLI mode you will need to enter the configuration Login
name and password (admin/admin by default).
Below shows some of the more popular CLI commands e.g. how to
check or modify the LAN IP address or to restore to factory defaults
etc...
:8
:1