Updating The Firmware - CyberData 011102 series Operation Manual

2.3.4 Updating the Firmware

Note
To update the firmware from your computer:
1. Please contact VoIP Technical Support to obtain the latest Singlewire-enabled Speaker firmware
2. Log in to the Singlewire-enabled Speaker home page as instructed in
3. Select Browse, and then navigate to the location of the Singlewire-enabled Speaker firmware
4. Click Submit.
Note
Note
Operations Guide
Updating from firmware versions earlier than 2.0.0 require a factory reset after the update
has been completed. This is due to a change in the way that the speaker stores its
configuration file.
file by submitting a contact form at the following website:
http://www.cyberdata.net/support/contactsupportvoip.php
Configuration Home Page".
file.
Do not reboot the board after pressing the Submit button.
This starts the update process. Once the Singlewire-enabled Speaker has updated the file,
the Firmware countdown page appears, indicating that the firmware is being written to
flash. The Singlewire-enabled Speaker will automatically reboot when the upload is
Figure 2-16. Upgrade Firmware Page
930320G
Installing the Singlewire-enabled Speaker
Configure the Speaker Parameters
Section 2.3.2, "Log in to the
CyberData Corporation
24