Table of Contents
Advertisement
4.0 Connect the Ethernet port(s)
The RJ-45 ports labeled Eth 0, Eth 1, Eth 2, and Eth 3 are the Auto-MDIX 10/100Base-T interfaces. These ports
are designed to connect directly to a 10/100Base-T device or network. You may connect this port to a hub or PC
using a straight through or crossover cable that is up to 328 ft long.
For detailed information about installing, configuring, and operating the CopperLink, refer to the CopperLink
Model 1314MDE User Manual at www.patton.com/manuals/CL1314MDE.pdf.
A.1 Compliance
EMC:
FCC Part 15, Class A
•
EN55022, Class A
•
EN55024
•
Safety:
UL 60950-1/CSA C22.2 N0. 60950-1
•
IEC/EN60950-1
•
1.2 Radio and TV Interference (FCC Part 15)
This equipment generates and uses radio frequency energy, and if not installed and used properly—that is, in
strict accordance with the manufacturer's instructions—may cause interference to radio and television recep-
tion. This equipment has been tested and found to comply with the limits for a Class A computing device in accor-
dance with the specifications in Subpart B of Part 15 of FCC rules, which are designed to provide reasonable
protection from such interference in a commercial installation. However, there is no guarantee that interference
will not occur in a particular installation. If the equipment causes interference to radio or television reception,
which can be determined by disconnecting the cables, try to correct the interference by one or more of the fol-
lowing measures: moving the computing equipment away from the receiver, re-orienting the receiving antenna,
and/or plugging the receiving equipment into a different AC outlet (such that the computing equipment and
receiver are on different branches).
CopperLink Model 1314MDE Quick Start Guide
5.0 Additional information
A.0 Compliance Information
5
Advertisement
Table of Contents
