2.3 Power up indication
Verify that the Power LED on the front panel illuminates and remains lit.
3.0 Connect the CopperLink interface
1.
Obtain single-twisted-pair cable with an RJ-45 plug connector at each end.
2.
Plug one end of the cable into the RJ-45 socket (labeled Line) on the CopperLink. Verify that the other
end of the cable is connected to the Line port on other CopperLink and that the port is correctly config-
ured.
When a link is established, the Line Link LED will turn on.
3.
4.0 Connect the Ethernet port(s)
The RJ-45 ports labeled Eth 0 and Eth 1 are the Auto-MDIX 10/100Base-T interface. These ports are designed to
connect directly to a 10/100Base-T device or network. You may connect this port to a hub or PC using a straight
through or crossover cable that is up to 328 ft long.
4
CL1314R front panel
Figure 3.
CopperLink™ Line Interface
Power LED
Line Link LED
Ethernet Port 1
Ethernet Port 0
Ethernet Port 0 Link LED
Ethernet Port 1 Link LED
Reset button
CopperLink Model 1314R Quick Start Guide