Din-Rail Mounting Installation - Korenix JetNet 3810G Series User Manual

Conductor
1 Positive Vport, Negative Vport
2 Positive Vport, Negative Vport
3 Negative Vport, Positive Vport
4
5
6 Negative Vport, Positive Vport
7
8
Note: This product is designed for in building installation only and is not intended
to be connected to exposed (outside plant) networks.

2.9 DIN-Rail Mounting Installation

The DIN-Rail clip is already attached on the rear side of JetNet 3810(Gf)/ 3806G/
3710G. It supports EN 50022 standard DIN Rail, in the following diagram includes the
dimension of EN 55022 DIN Rail for
your reference.
The DIN rail should behind the spring
when install the JetNet 3810G series
onto the standard DIN Rail.
Follow the steps below to mount the
JetNet 3810G series on the DIN-Rail
track.
1. Insert the upper end of the
DIN-Rail clip into the back of
the DIN-Rail track from its
upper side
2. Lightly push the bottom of the
DIN-Rail clip into the track.
PD Pinout
Mode A
Korenix
JetNet 3810(Gf)/ 3806G/ 3710G
Mode B
Positive Vport,
Positive Vport,
Negative Vport,
Negative Vport,
18