Table of Contents
Advertisement
3. Mounting Installation
3-1. DIN-Rail Mounting
The DIN-Rail clip is already attached on the rear side of JetNet 2205 series. JetNet
2205 series supports EN 50022 standard DIN Rail, in the following diagram
includes the dimension of EN 55022 DIN Rail for your reference
The DIN rail should behind the
spring when install the JetNet
2205 series onto the standard
DIN Rail.
Follow the steps below to mount
the JetNet 2205 series to the
DIN-Rail track.
1. Insert the upper end of the
DIN-Rail clip into the back of
the DIN-Rail track from its
upper side
2. Lightly push the bottom of the
DIN-Rail clip into the track.
3. Check if the DIN-Rail clip is
tightly attached to the track.
4. To remove the JetNet 2205
series from the track, reverse
the steps above.
11
Advertisement
Table of Contents
