Table of Contents
Advertisement
AP advanced
The advanced wireless configuration page allows you to modify advanced wireless access point settings of your router. These
settings are set to optimal settings for most situations and should not be changed unless you are aware of the effect that your
changes will have.
OPTION
Maximum number of connected
clients
Client idle timeout
Beacon interval
Delivery traffic indication
message (DTIM) rate.
Fragment threshold
RTS threshold
TX power
Short preamble
www.netcommwireless.com
Ver 1.4
Figure 29 - Wireless Settings - Advanced
The maximum number of wireless clients that may connect to the access point. The default setting is 31.
This may be a maximum of 255.
The time in seconds that a wireless client session can be idle before the router cancels the session and
defines the wireless client as not connected.
Interval of time in which the wireless router broadcasts a beacon which is used to synchronize the wireless
network.
Enter a value in milliseconds between 1 and 255 for the Delivery Traffic Indication Message (DTIM). A DTIM is
a countdown informing clients of the next window for listening to broadcast and multicast messages.
This specifies the maximum size of a packet during the fragmentation of data to be transmitted. If you set this
value too low, it will result in bad performance.
When the packet size is smaller than the RTS threshold, the wireless router will not use the RTS/CTS
mechanism to send this packet.
This determines the transmitting or output power of the antenna.
Enable or disable short preambles in use on the wireless network. Using short preambles should improve
throughput, however some wireless network adapters must use long preambles.
Table 12 - Wireless Settings - Advanced Configuration Items
DEFINITION
NetComm Wireless NTC-40WV Industrial Indoor 3G Router with Voice
31
Advertisement
Table of Contents
