Table of Contents
Advertisement
2.
Click the Profile toggle key to turn the profile on. Additional settings appear.
3.
In the Profile name field, enter a name for the profile. This name is only used to identify the profile on the router.
4.
Ensure that the Automatic APN selection toggle key is set to off. If it is not, click it to toggle it to the off position.
5.
In the APN field, enter the APN Name (Access Point Name) and if required, use the Username and Password fields to
enter your login credentials.
6.
If your mobile broadband carrier allows you to select a preferred IP address, select the Static IP address toggle key to turn
it to the ON position then enter your preferred IP address into the Preferred IP address field.
7.
Next to Authentication type, select either CHAP or PAP depending on the type of authentication used by your provider.
8.
The Reconnect delay field specifies the number of seconds to wait between connection attempts. The default setting of 30
seconds is sufficient in most cases but you may modify it to wait up to 65535 seconds if you wish.
9.
The Reconnect retries field specifies the number of times to attempt a network connection if the router fails to establish a
connection. It is set to 0 by default which causes the router to attempt to reconnect indefinitely.
10. The Metric value is used by router to prioritise routes (if multiple are available) and is set to 20 by default. This value is
sufficient in most cases but you may modify it if you are aware of the effect your changes will have on the service.
NetComm Wireless NTC-40WV Industrial Indoor 3G Router with Voice
18
Figure 10 - Data connection settings - Profile turned on
www.netcommwireless.com
Ver 1.4
Advertisement
Table of Contents
