Table of Contents
Advertisement
WAB–3000 Wireless Access Point
Lighnting Arrestor Installation
Examine the lightning arrestors and remove and discard the following
items (if necessary). See figure below.
• Securing Nut
• Washer
• Ring Terminal (but retain the screw)
Ring Terminal
Attach the 10, 12, and 18-inch wires to the lightning arrestors ensur-
ing that the smaller ring terminals and with identifying labels are used.
Tighten the ring terminal securely using a screwdriver.
To install the lightning arrestors to the WAB–3000, attach one end of
the lightning arrestor to the WAB–3000's N connector. Make sure that the
lightning arrestor with the 12-inch wire is mounted closer to the ground
stud (see figure). Tighten the two lightning arrestors to the N connector
finger tight.
������ ���������
�������� ����
������� ���� ��
������ ������� ����
29000171-002 A
���������
�� �����
����
������
Chapter 2: Hardware Installation
Securing Nut
Washer
������� ����
������ ���������
�������� ����
������� ����
���������
��������
�������
19
Advertisement
Table of Contents
