Point-To-Multipoint Bridging Setup Guide - Manual Mode; Point-To-Multipoint Bridging Setup Guide - Auto Mode - LevelOne WAB-3000 User Manual

WAB–3000 Wireless Access Point
The above recommended setup requires only Bridge 1 to be set in
point-to-multipoint mode. It is possible to set all bridges in point-to-
multipoint mode, in which case , each bridge would have to contain the
BSSID for each of the other bridges and Spanning Tree Protocol must be
Enabled. Complete any other setup screens following general instructions
in Chapter 3.
Repeater Bridge Configuration
A repeater setup can be used to extend the wireless signal from one
bridge connected to an Ethernet LAN wirelessly so that another bridge
can control a wireless LAN at a distance.
�������
���
������
Repeater Bridging Setup Guide - Manual Mode
Direction
Wireless Bridge — General (Manual BridgingMode)
Bridging Mode
Signal Strength
LED MAC
Spanning Tree
Protocol
Wireless Bridge — Radio
Wireless Mode
Tx Rate
Channel No.
Tx Power Mode
Propagation Dis-
tance
RTS Threshold
BSSID
Wireless Bridge — Encyption
Wireless Configu-
ration – Bridging
Encryption
29000171-002 A
���
������
�������
������ �
������ �
�������
��������
Bridge 1
manual
Not Assigned (select
from drop-down list)
Enable (or Disable if
no bridging loop pos-
sible)
802.11a
AUTO
Same as Bridge 2
Auto
< 5 Miles
2346
Add Bridge 2's MAC
Select appropriate key
type/length and enter
key value. Must be the
same as that on the
other two Bridges.
Chapter 5: Wireless Bridge Configuration
�������
������ �
�������
��������
Bridge 2
manual
Not Assigned (select
from drop-down list)
Enable (or Disable if
no bridging loop pos-
sible)
802.11a
AUTO
Same as Bridge 1
Auto
< 5 Miles
2346
Add Bridge 1's and
Bridge 3's MAC
Select appropriate key
type/length and enter
key value. Must be the
same as that on the
other two Bridges.
���
������
Bridge 3
manual
Not Assigned (select
from drop-down list)
Enable (or Disable if no
bridging loop possible)
802.11a
AUTO
Same as Bridge 1
Auto
< 5 Miles
2346
Add Bridge 2's MAC
Select appropriate key
type/length and enter
key value. Must be the
same as that on the other
two Bridges.
87