Table of Contents
Advertisement
WAB–3000 Wireless Access Point
Repeater Bridging Setup Guide - Auto Mode
Direction
Wireless Bridge — General (Auto Bridging Mode)
Bridging Mode
SSID
Max Auto Bridges
Bridge Priority
Signal Strength
Threshold
Signal Strength
MAC
Wireless Bridge — Radio
Wireless Mode
Tx Rate
Channel
Tx Power Mode
Propagation Dis-
tance
RTS Threshold
Wireless Bridge — Encyption
Wireless Configu-
ration – Bridging
Encryption
Wireless Bridge — MAC Address Filtering
Filtering
Filter Type
MAC Address
With this configuration, each bridge can control a wireless LAN. All
wireless clients must have the same SSID as the bridges on the AP card
channel. All clients can roam between the three bridges.
All other setup screens should be completed following the guidelines
in Chapter 3.
88
Bridge 1
Bridge 2
auto
auto
Must be the same as
Must be the same as
Bridge 2
Bridge 1
40 (range 1-40)
40 (range 1-40)
40 (1-40)
40 (1-40)
9%
9%
Enter from list at
Enter from list at the
the bottom of the
bottom of the screen
screen
802.11a
802.11a
AUTO
AUTO
Same as Bridge 2
Same as Bridge 1
Auto
Auto
< 5 Miles
< 5 Miles
2346
2346
Select appropriate
Select appropriate
key type/length
key type/length
and enter key
and enter key value.
value. Must be the
Must be the same as
same as that on the
that on the other 2
other 2 Bridges.
Bridges.
Enable/Disable
Enable/Disable
Deny All/Allow All Deny All/Allow All Deny All/Allow All
Add MAC address
Add MAC address
of bridges
of bridges
Chapter 5: Wireless Bridge Configuration
Bridge 3
auto
Must be the same
as Bridge 1
40 (range 1-40)
40 (1-40)
9%
Enter from list at
the bottom of the
screen
802.11a
AUTO
Same as Bridge 1
Auto
< 5 Miles
2346
Select appropriate
key type/length
and enter key
value. Must be the
same as that on the
other 2 Bridges.
Enable/Disable
Add MAC address
of bridges
29000171-002 A
Advertisement
Table of Contents
