Chapter 2 Hardware Installation; Panel Description - LevelOne wap-0007 User Manual

Chapter 2 Hardware installation

This chapter summarizes the appearance of ReOS_SE software platform WAC - 1000 / WAC - 1001, then describes
how to install the device.

2.1 Panel description

The front panel has 5 LAN ports (10/100M), an external USB interface, and the casing size is 9 inches. The front
panel is shown in the schematic diagram below.
2.1.1 Description of LED lights
LED lights
PWR
SYS System Status LED
Link/Act Port Status LED
USB USB Port Status LED
2.1.2 Description of interfaces
Interface Meaning
LAN LAN ports
USB USB port
2.1.3 Reset button
Reset button can be used to recover the device's factory configuration when you forget the administrator password.
Method: In the process of charged operation, hold down the Reset button for more than 5 seconds, then release the
button, and the device will be returned to the factory settings, and automatically restart.
Note: The above operations will delete all the original device configuration, please use it with care!
Figure 2- 1 Front Panel -- WAC-1000
Description
It is constantly on when the power supply is working
Power LED
properly.
It flashes at the frequency of 2 times per second, when the
system burden is heavy, the flashing frequency drops;
normally on or normally off in failure.
When a device is properly connected to a port, the status
LED that corresponds to the port stays lit, and it will flash
if there is flow.
USB light is on, which means the USB interface is being
used.
Table 0-1 Description of LEDs
Integrated with multiple
switched Ethernet ports.
Provide an external USB
interface.
Table 0-2 Description of Ports
Function
Notes
LAN (RJ-45) port supports
adaptive positive and negative
lines.
Connect the USB disk, to store
the software, profiles, etc.
obtained by devices.
Remarks
4