Table of Contents
Advertisement
WAB–2000 Wireless Access Point
Earth Ground Connection
Attach the earth ground ring terminal to the WAB–2000's grounding
stud. Make sure the ring terminal is against the unit's metal case. The
earth ground ring terminal should be the first connection on the unit's
grounding stud.
NOTE: The cable used to connect to a proper earth ground must be
AWG 10 or heavier. This cable should be kept as short as possible
Lighnting Arrestor Installation
To install the lightning arrestor option, attach one end of the lightning
arrestor to the WAB–2000's antenna connector. Attach the antenna (or the
antenna cable) to the other end of the lightning arrestor.
�� �����
������
Attach the ring terminal from the Lightning Arrestors' ground cable
to the grounding stud on the WAB–2000 unit. The lightning arrestor's
ring terminal should be attached to the unit after the earth ground ring
terminal is attached.
Perform this same procedure for every antenna installed on the unit.
It is recommended that this Outdoor Protection Kit be replaced every
three years. If the unit is operated in an area subject to intense lightning
activity, it is recommended that the Outdoor Protection Kit be replaced
every year.
16
���������
����
Chapter 2: Hardware Installation
���������
��������
�������
29000155-001 A
Advertisement
Table of Contents
