Table of Contents
Advertisement
WAB–3000 Wireless Access Point
The following items are accessories:
The WAB–3000 can be mounted outdoors on a high post to achieve
the best bridge result.If mounted outdoors, the outdoor protection kit
must be used to prevent lightning damage.
To comply with FCC RF exposure compliance requirements,
the antennas used with the WAB–3000 must be installed with
a minimum separation distance of 20 cm from all persons, and must
not be co-located or operated in conjunction with any other antenna or
transmitter. Installation should be accomplished using the authorized
cables and/or connectors provided with the device or available from the
manufacturer/distributor for use with this device. Changes or modifica-
tions not expressly approved by the manufacturer or party responsible for
this FCC compliance could void the user's authority to operate the equip-
ment.
Installation Instructions
The WAB–3000 is intended to be installed as part of a complete wire-
less design solution.
This manual deals only with the WAB–3000 device and its accessories.
The purpose of this chapter is the description of the device and its iden-
tifiable parts so that the user is sufficiently familiar to interact with the
physical unit. Preliminary setup information provided below is intended
for information and instruction of the wireless LAN system administra-
tion personnel.
It is intended that the user not open the unit. Any maintenance re-
quired is limited to the external enclosure surface, cable connections, and
to the management software (as described in chapter three through five)
only. A failed unit should be returned to the manufacturer for mainte-
nance.
14
Chapter 2: Hardware Installation
29000171-002 A
Advertisement
Table of Contents
