Eapol-Based Security - Nortel business policy switch 2000 User Manual

The BayStack 450-1GBIC MDA supports the following GBICs:
• 1000BASE-SX—This GBIC uses shortwave 850 nm fiber optic connectors to
connect devices over multimode (550 m or 1,805 ft) fiber optic cable.
• 1000BASE-LX—This GBIC uses longwave 1,300 nm fiber optic connectors
to connect devices over single mode (5 km or 3.1 mi) or multimode (550 m or
1,805 ft) fiber optic cable.
• 1000BASE-XD—This GBIC uses single mode fiber to connect devices over
distances up to 50 km (or 31 mi), depending on the quality of the cable.
• 1000BASE-ZX—This GBIC uses single mode fiber to connect devices over
distances up to 70 km (or 43 mi), depending on the quality of the cable. The
ports on this GBIC operate only in full-duplex mode.
Refer to Installing Media Dependent Adapters (MDA)s and Installing Gigabit
Interface Converters and Small Form Factor Interface Converters for more
information on installation, technical specifications, connectors, and cabling for
the BayStack 450-1GBIC MDA.

EAPOL-based security

BPS 2000 software version 1.1 provides support for security based on the
Extensible Authentication Protocol over LAN (EAPOL), which uses the EAP as
described in the IEEE Draft P802.1X to allow you to set up network access
control on internal LANs.
Refer to "Security" on page 75
security. For information on configuring EAPOL-based security using the
Console Interface (CI) menus, refer to Chapter 3. To configure this feature using
the Web-based management system, refer to Using Web-based Management for
the Business Policy Switch 2000 Software Version 2.0. To use Device Manager
(DM) to configure EAPOL-based security, refer to Reference for the Business
Policy Switch 2000 Management Software Version 2.0. And, to configure this
feature using CLI commands, refer to Reference for the Business Policy Switch
2000 Command Line Interface Software Version 2.0.
for complete information on EAPOL-based
Using the Business Policy Switch 2000 Version 2.0
66