Policy-Enabled Networks With Qos Metering; Support For The Baystack 450-1Gbic Mda (Gbic Mda) - Nortel business policy switch 2000 User Manual

You must change the Telnet access field through direct access to the interface; you
cannot change the Telnet access field through Telnet. You must set the Telnet
feature after the first power-up.
Note: To avoid locking a user out of the switch, Nortel Networks
recommends that you configure ranges of IP addresses that you allow
access.
When you configure the access, you are setting access for the next session. The
current session any user has open is unaffected.
For information on configuring the IP manager list, refer to Chapter 3, Using
Web-based Management for the Business Policy Switch 2000 Software Version
2.0, and Reference for the Business Policy Switch 2000 Command Line Interface
Software Version 2.0.

Policy-enabled networks with QoS metering

With version 1.1, the BPS 2000 supports the traffic policing, or metering, feature
of IETF Differentiated Services (DiffServ) Quality of Service (QoS) architecture.
Refer to "Policy-enabled networking" on page
description of policy-enabled networks, and refer to Chapter 4 for a complete
discussion of policy-enabled networks, Differentiated Services (DiffServ), and
Quality of Service (QoS). For information on configuring policy-enabled
networks, DiffServ, and QoS, refer to Using Web-based Management for the
Business Policy Switch 2000 Software Version 2.0, Reference for the Business
Policy Switch 2000 Command Line Interface Software Version 2.0, and Reference
for the Business Policy Switch 2000 Management Software Version 2.0.

Support for the BayStack 450-1GBIC MDA (GBIC MDA)

The BPS 2000 software version 1.1 provides support for the Gigabit Interface
Connector (GBIC) MDA, named the BayStack 450-1GBIC MDA. The BayStack
450-1GBIC MDA provides only two priority queues.
70, for a more complete
Using the Business Policy Switch 2000 Version 2.0
65