Installing the ETERNUS CS800 Components
Installation of the RX300 S5 Server in PRIMECENTER/DataCenter Rack
For installation in a PRIMECENTER/DataCenter rack, the following parts are required:
Support bracket
●
One support system on the left and one on the right
●
I
Fitting the Support Bracket
When mounting the left telescopic rail in the PRIMECENTER/DataCenter Rack, the
supplied support bracket must first be mounted on the rear left support upright flush with
the bottom edge of the device.
Figure 22: Fitting the support bracket
Position the support bracket at the corresponding height on the rear left support upright,
(place knob in the corresponding hole and secure it as described in the Technical Manual
for the rack in question.
U41842-J-Z125-1-76
General information is provided in the Technical Manual for the PRIMECENTER
and/or DataCenter Rack.
Installing the CS800 System in the Rack
47