Fujitsu ETERNUS CS800 Getting Started Manual page 71

Hardware Description
Item Indicator, Button Description
1 POWER LED
(green)
2 READY LED
(green)
3 FAULT LED
(orange)
4 IDENTIFY LED
(blue)
5 CACHE LED
(green)
6 Power Switch
Table 8: DX80 Indicators and Buttons on the Left Side of the Front Panel (with Front Cover)
Item Indicator, Button Description
1 AutoPWR
2 MODE SEL
3 IP RST
Table 9: DX80 Switches on the Left Side of the Front Panel (with Front Cover Removed)
U41842-J-Z125-1-76
Glows green when the power is turned on.
Glows green when device is available for use.
Glows orange when an internal device part abnormality has
been detected.
Blinks orange when a device part which needs preventive
replacement has been detected.
Not used with CS800.
Glows green when there is data in the device cache.
Blinks when a power failure has occurred and the cache data is
being saved to flash memory.
Used to turn the device on and off.
Enables the AC Auto-Link Mode
(this function automatically turns on the linked device once AC
power is supplied).
This switch is set to "OFF" as the factory setting.
Enables the device power to be turned on via power linkage.
This switch is set to "ON" as the factory setting and should not
be set to "OFF".
IP Reset.
V
Do not use!
Clicking once would switch the IP addresses of the two
controller modules of the storage unit.
Clicking twice in succession within a two second interval would
revert the IP addresses to their factory settings.
CS800 Basic Storage Module
71