Fujitsu ETERNUS CS800 Getting Started Manual page 83

Initial Configuration
4. Configure the network settings on the service laptop:
I
a) On the Windows Start menu, click Settings > Control Panel > Network and
b) Right-click the network connection that corresponds to the Ethernet port you have
c) Select Internet Protocol (TCP/IP) in the list of connections, and then click
Figure 58: Internet Protocol (TCP/IP) Properties Window
d) Select Use the following IP Address and then enter the following information:
U41842-J-Z125-1-76
This procedure assumes you are running Windows XP on the computer. The
steps might be different if you are using another operating system.
Internet Connections > Network Connections.
connected to the RX300 S5 server (for example, Local Area Connection), and
click Properties.
Properties.
The Internet Protocol (TCP/IP) Properties window displays (see
V
Depending on the configuration you may need to reset the network settings
to their original state later. Therefore keep in mind or write down the current
settings before you make any changes.
IP address - 10.1.1.2
●
Subnet mask - 255.255.0.0
●
Accessing and Completing the Setup Wizard
figure 58).
83