Fujitsu ETERNUS CS800 Getting Started Manual page 73

Hardware Description
Item Indicator, Button Description
1 SCU Status LED
(green)
2 ID (Identify) LED
(blue)
3 SAS (DE) Link
LED
(green/orange)
4 SAS (OUT) port
5 Act LED
(green)
6 RMT port (left)
MNT port (right)
7 Link LED
(green)
8 Host Linkup/Fault
LED
(orange)
9 Host FC port
10 PWC port
11 STS (Status; Unit
Ready/Fault) LED
(green/orange)
12 MST (Master)
LED
(green)
Table 11: DX80 Indicators and Buttons on the Left Side of the Front Panel (with Front Cover)
U41842-J-Z125-1-76
Grows green when the SCU (System Capacitor Unit) is normal.
Blinks green when being charged (for about one minute after
the device power is turned on).
Not used with CS800.
Glows green when link has been established.
Blinks orange when preventive replacement is being performed.
Connector for a miniSAS cable
Used to connect the basic DX80 module to a DX80 expansion
module.
Glows green when data is being sent and received.
LAN ports (1000Base-T / 100Base-TX / 10Base-T) for device
management
(MNT: Management, RMT: Remote Management)
RJ45 connectors for LAN cables
Glows green when the related link has been established.
Glows orange when a fault has been detected in the Fibre
Channel port.
0 (left), 1 (right)
Dual LC connectors for Fibre Channel cables connecting the
DX80 with the RX300 S5.
Not used.
Glows green during normal operation.
Glows orange during the post power on initialization phase.
Also glows orange to indicate a fault has been detected.
Glows green when this unit acts as the master controller
module.
CS800 Basic Storage Module
73