Hard Drive Carrier Indicators - Fujitsu ETERNUS CS800 Getting Started Manual

Hardware Description
Item Indicator, Button Description
1 ID (Identify) LED
(blue)
2 –
3 SAS (DE) Linkup
LED
(green/orange)
4 SAS (OUT) port
5 SAS (DE) Linkup
LED
(green/orange)
6 SAS (IN) port
7 STS (Status; Unit
Ready/Fault) LED
(green/orange)
Table 15: Indicators on the Rear of the DX80 Expansion Module

Hard Drive Carrier Indicators

3.5'' hard drive carriers are used in the storage modules. The 3.5'' hard drive carrier itself
has no LED indicator; instead at the storage frame, there is one LED indicator for each hard
drive carrier (see red arrows in
Figure 54: 3.5'' Hard Drive Carrier and Related LEDs
Table 16
U41842-J-Z125-1-76
Not used with CS800.
Not used with CS800.
Glows green when link has been established.
Blinks orange when preventive replacement is being performed.
Connector for a miniSAS cable to the following DX80 module (if
existent)
Glows green when link has been established.
Blinks orange when preventive replacement is being performed.
Also glows orange to indicate a fault has been detected.
Connector for a miniSAS cable from the previous DX80 module
Glows green during normal operation.
Glows orange during the post power on initialization phase.
Also glows orange to indicate a fault has been detected.
describes the behavior of the LED indicator.
figure 54).
Hard Drive Carrier Indicators
77