Table of Contents
Advertisement
1
Installing the Anti-siphon Fill
Receptacle
Parts needed for this procedure:
1
90 degree fitting
1
Quick coupler
1
Hose adapter
1
Fill receptacle bracket
1
Flange-head bolt, 5/16 x 3/4 inch
1
Anti-siphon hose
Procedure
1. Place the fill receptacle bracket over the threaded
hole in the tank and secure it with a flange-head bolt
(5/16 x 3/4 inch) (Figure 3).
1. Fill receptacle bracket
2. Threaded hole in the tank
3. Flange bolt, 5/16 x 3/4 inch 7. Anti-siphon hose
4. 90 degree elbow fitting
2. Place the threaded end of the 90 degree elbow fitting
through the bracket and thread the quick coupler onto
it, securing it to the bracket (Figure 3).
Note: Install the fitting with the open end pointing
toward the large opening in the bracket and toward the
tank opening so the water will arc into the tank when
you fill it.
3. Install the hose adapter into the quick coupler
(Figure 3).
Figure 3
5. Quick coupler
6. Hose adapter
4. Lock the adapter into place by swinging the levers
toward the adapter and then secure them with the
hairpin cotters (Figure 3).
5. Install the anti-siphon hose through the large opening
on the bracket and onto the barbed end of the 90
degree elbow fitting (Figure 3).
Important: Do not lengthen the hose to allow
contact with the tank fluids.
2
Installing the Spray Pro
Monitor
Parts needed for this procedure:
1
Spray Pro Monitor
1
Spray Pro Decal
1
Bracket
2
Flange-head bolt, 3/4 inch
2
Flange nut, 1/4 inch
2
Knob
2
Washer
2
Carriage bolt
Procedure
1. Install the Spray Pro Decal to the monitor (Figure 4).
1. Spray pro monitor
2. Decal, Upper half
Note: Be sure to orient the decal as shown in
Figure 19.
2. Install the monitor bracket on the dash (Figure 5) using
2 flange-head bolts (1/4 x 3/4 inch) and 2 flange nuts
(1/4 inch).
14
Figure 4
3. Decal, Lower half
Advertisement
Table of Contents
