Daily Maintenance Checklist - Toro 41199 Operator's Manual

Maintenance Service
Interval
Every 400 hours
Every 800 hours
Important: Refer to your engine Operator's Manual for additional maintenance procedures.

Daily Maintenance Checklist

Duplicate this page for routine use.
Maintenance Check Item
Check the brake and parking brake
operation.
Check the gear shift/neutral operation.
Check the fuel level.
Check the engine oil level.
Check the transaxle oil level.
Inspect the air filter.
Inspect the engine cooling fins.
Check any unusual engine noises.
Check any unusual operating noises.
Check the tire pressure.
Check for fluid leaks.
Check the instrument operation.
Check the accelerator operation.
Clean the suction strainer.
Check toe-in.
Lubricate all grease fittings.
Touch up and damaged paint.
1
Immediately after every washing, regardless of the interval listed
Maintenance Procedure
• Grease the actuator rod bearings.
• Complete all yearly maintenance procedure specified in the engine operator's
manual.
• Inspect the fuel lines.
• Drain and clean the fuel tank.
• Inspect the pump diaphragm and replace if necessary. (see an Authorized Toro
Service Distributor)
• Inspect the pressure dampener bladder and replace if necessary. (see an Authorized
Toro Service Distributor)
• Inspect the pump check valves and replace if necessary. (see an Authorized Toro
Service Distributor)
• Change the pump drive gearbox fluid.
• Check boom actuator hydraulic oil for air bubbles.
• Inspect the center boom nylon pivot bushings.
• Change the transaxle/hydraulic fluid and clean strainer.
• Replace the hydraulic filter.
For the week of:
Mon.
1
Tues. Wed. Thurs.
36
Fri. Sat. Sun.