Toro 41199 Operator's Manual page 58

assembly. Make sure to account for the springs
in the valve (Figure 73).
E. Clean the pistons and replace any worn O-rings.
F. Coat all piston O-rings with vegetable oil and
reinstall in the valve assembly with the screws
previously removed. Make sure to install the
springs into the valve assembly.
G. Secure the valve seats to the valve assembly with
the 3 forks previously removed.
H. Mount the hose loom bracket to the sprayer frame
with the 2 screws and nuts previously removed.
5. Add a rust inhibiting, non-alcohol based, RV antifreeze
solution to the system and run the pump for a few
minutes to circulate it through the system, then drain
the spray system as completely as possible.
6. Use the boom lift switches to raise the booms. Raise
the booms until have moved completely into boom
transport cradle forming the "X" transport position
and the boom cylinders are fully retracted. Make
sure the boom cylinders are fully retracted to prevent
actuator rod damage.
7. Inspect the brakes; refer to Inspecting the Brakes in the
Brake Maintenance section.
8. Service the air cleaner; refer to Servicing the Air
Cleaner in the Engine Maintenance section.
9. Grease the sprayer; refer to the Lubrication section.
10. Change the crankcase oil; refer to Servicing Engine Oil
in the Engine Maintenance section.
11. Check the tire pressure; refer to Checking the Tire
Pressure in the Drive System Maintenance section.
12. For storage over 30 days, prepare the fuel system as
follows:
A. Start the engine and run it at idle speed for
approximately 2 minutes.
B. Stop the engine.
C. Flush the fuel tank with fresh, clean fuel.
D. Secure all the fuel system fittings.
13. Use the electric starter to crank the engine and
distribute the oil inside the cylinder.
14. Remove the battery from the chassis, check the
electrolyte level, and charge it fully; refer to Servicing
the Battery in the Electrical System Maintenance
section.
Note: Do not connect the battery cables to the battery
posts during storage.
Important: The battery must be fully charged to
prevent it from freezing and being damaged at
temperatures below 32 degrees F (0 degrees C). A
fully charged battery maintains its charge for about
50 days at temperatures lower than 40 degrees F (4
degrees C). If the temperatures will be above 40
degrees F (4 degrees C), check the water level in
the battery and charge it every 30 days.
15. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is damaged.
16. Check the condition of all spray hoses, replacing any
that are damaged or worn.
17. Tighten all hose fittings.
18. Paint all scratched or bare metal surfaces.
Paint is available from your Authorized Service Dealer.
19. Store the machine in a clean, dry garage or storage area.
20. Remove the ignition key and put it in a safe place out
of the reach of children.
21. Cover the machine to protect it and keep it clean.
58