Toro 41199 Operator's Manual page 41

1
Figure 43
1. Actuator
2. Actuator rod
3. Boom pivot pin housing
3. Lift up on the boom and remove the pin (Figure 43).
Slowly lower the boom to the ground.
4. Inspect the pin for any damage, replace if necessary.
5. Manipulate the actuator rod bearing end and apply
grease into the bearing (Figure 44). Wipe off excess
grease.
Figure 44
Right boom
1. Grease bearing
6. Raise the boom to align the pivot with the actuator rod.
While holding the boom, insert the pin through both
boom pivot and actuator rod (Figure 43).
7. With the pin in place, release the boom and secure the
pin with the cotter removed previously.
4
2
5
3
G002016
4. Cotter
5. Pin
8. Repeat the procedure for each actuator rod bearing.
41