Toro 41199 Operator's Manual page 20

Important: The range selector must be in the neutral
position for the switch to work.
Fuel Gauge
The fuel gauge is located on top of the fuel tank, on the right
side of the machine and shows the amount of fuel in the tank.
Master Spray Lever
The master spray lever allows you to start or stop the spray
operation. Rotate the lever forward to enable the spray system
and rearward to disable it (Figure 15). When the master spray
lever is in the Off position, the Spray Pro screen reads "Hold."
Figure 15
1. Master spray lever
2. Boom levers
Boom Levers
The boom levers are located at the rear of the control panel
to the right of the seat (Figure 15). Push each lever down
to turn the corresponding boom section on and up to turn
them off. These levers will only affect the spray system when
the master spray lever is on.
Application Rate Knob
The application rate knob is located on the control panel to
the right of the seat (Figure 15). Rotate the knob clockwise
to increase the spray system pressure or counterclockwise to
decrease pressure.
Pump Switch
The pump switch is located on the control panel to the right
of the seat (Figure 16). Toggle this switch forward to run the
pump or rearward to stop the pump.
Important: Only engage the pump switch when the
engine is at low idle to avoid damaging the pump drive.
3. Application rate knob
4. Pump switch
1. Pump switch
2. Boom lift switch, left and
right
Boom Lift
The boom lift switches are used to raise the left and right
boom respectively (Figure 16).
Foam Marker Switch Locations
(Optional)
If you install the electric boom lift, sonic boom, and foam
marker kit, you will add switches to the control panel for
controlling their operation. The sprayer comes with plastic
plugs in these locations.
Sonic Boom (Optional)
The Sonic Boom switch is a rocker switch used to operate the
Sonic Boom. Toggle switch forward for automatic, rearward
for manual and center for Off.
Application Rate Control Valve
This valve controls the amount of fluid that is routed to the
booms by directing fluid flow to the booms or the bypass
hose to the tank (Figure 17). To control this valve, rotate
the application rate knob on top of the valve to obtain the
desired pressure.
20
Figure 16
3. Foam marker switch, left
and right
4. Sonic boom switch