Toro 41199 Operator's Manual page 29

Figure 24
1. Rinse tank (for use with the optional rinse kit, 106-4842)
1. Stop the sprayer, set the parking brake, place the range
selector in the Neutral position, and turn off the
engine. The tank will drain to left side of the machine.
2. Locate the tank drain valve on the right side of the
machine (Figure 25). The valve is on the fender bracket
next to the battery.
1
2
Figure 25
1. Tank drain
2. Lynch pin
A. Remove the lynch pin on the bracket securing the
drain valve to the machine and let the valve rest
on the ground.
B. Open the valve to drain any unused material
from the tank and dispose of it according to local
codes and the material manufacturer's instructions
(Figure 26). This allows any residual material in
the line to drain.
1
g0131 10
1. Lynch pin
2. Valve closed
3. When the tank has drained completely, close the drain
valve and install the valve to bracket with the lynch pin
removed previously (Figure 26).
4. Fill the tank with at least 50 US gallons (190 L) of clean
fresh water and close the cover.
Note: You can use a cleaning/neutralizing agent in
the water as needed. On the final rinse, use only clean,
clear water.
5. Start the engine.
6. With the range selector in the Neutral position, press
the accelerator pedal to the floor and set the neutral
engine speed lock switch to the On position.
7. Ensure that the agitation control valve is in the On
position.
8. Set the pump switch to the On position and use the
application rate switch to increase the pressure to a
high setting.
29
2
3
4
g0131 11
Figure 26
3. Tank drain
4. Valve open