Installing The Anti-Siphon Fill Receptacle; Installing The Spray Pro Monitor - Toro 41164 Operator's Manual

Installing the Anti-siphon Fill
Receptacle
1. Place the fill receptacle bracket over the threaded hole
in the tank and secure it with a flange-head bolt
(5/16 x 3/4 inch) (Fig. 2).
7
6
5
Figure 2
1. Fill receptacle bracket
2. Threaded hole in the tank
3. Flange bolt,
5/16 x 3/4 inch
2. Place the threaded end of the 90 degree elbow fitting
through the bracket and thread the quick coupler onto it,
securing it to the bracket (Fig. 2).
Note: Install the fitting with the open end pointing
toward the tank opening so the water will arc into the
tank when you fill it.
3. Install the hose adapter into the quick coupler (Fig. 2).
4. Lock the adapter into place by swinging the levers
toward the adapter and then secure them with the
hairpin cotters (Fig. 2).
5. Install the anti-siphon hose on the barbed end of the 90
degree elbow fitting (Fig. 2).
Important
Do not lengthen the hose to allow contact
with the tank fluids.
Installing the Spray Pro
Monitor
1. Install the monitor bracket on the dash (Fig. 3) using 2
flange-head bolts (1/4 x 3/4 inch) and 2 flange nuts
(1/4 inch).
4
1
3
2
m-7368
4. 90 degree elbow fitting
5. Quick coupler
6. Hose adapter
7. Anti-siphon hose
13
1
4
Figure 3
1. Spray Pro monitor
2. Bracket
2. Loosely install the 2 carriage bolts, rubber washers, and
knobs on the bracket as shown in Figure 3 and 4.
Note: Install the carriage bolts and rubber washers inside of
the bracket and the knobs on the outside.
2
1
4
Figure 4
1. Carriage bolt
2. Rubber washer
3. Remove the large grommet from the hole in the dash
and thread the cable on the monitor through the
grommet and the dash.
4. Install the grommet into the dash.
5. Apply the Spray Pro Decal to the monitor. Be sure to
orient the decal as shown in Figure 24.
6. Install the Spray Pro monitor over the carriage bolt
heads (Fig. 3) and tighten the knobs to secure it.
7. Connect the Spray Pro wire connector to the open wire
connector located under the dash.
4
2
3
3. Flange-head bolts,
1/4 x 3/4 inch
4. Knob
3
3. Knob
4. Bracket