Do Not - Christie E SERIES User Manual

Section 1: Safety
1.2 Do
Always power down the projector and disconnect all power sources before

servicing or cleaning.
Use a soft cloth moistened with a mild detergent to clean the display

housing.
Disconnect the power plug from the AC outlet if the product is not being

used for an extended period of time.
Operate the projector under the following conditions:

-
Operating temperature range: 5°C to 35°C
-
Storage temperature range: -10°C to 60°C
-
Humidity range: 5% to 80 % RH (Max.), non condensing
-
Operating altitude: 10,000 ft. maximum
Use only the AC power cord supplied. Do not attempt operation if the AC

supply and cord are not within the specified voltage and power range.
Remove the lens plug from the lens opening in the projector before

installing the lens. Retain the lens plug for projector transportation to
protect the optical components from dust and debris.
1.3

Do not

Do not block the ventilation slots and openings on the unit.

Do not use abrasive cleaners, waxes or solvents to clean the unit.

Do not look into the lens.

Do not allow anything to rest on the power cord.

Do not attempt to access the lamp while the lamp is ON. After turning the

lamp OFF, it is critical that you wait at least 10 minutes before handling
the lamp. This provides sufficient time for the lamp cooling fans to properly
cool the lamp.
1-2
Downloaded from ProjectorsManual.com Manuals
E Series User Manual
020-000287-01 Rev. 1 (01-2011)