Appendices; Troubleshooting - Christie E SERIES User Manual

5.

APPENDICES

5.1

Troubleshooting

If you experience a problem with your projector, please refer to the following
information. If a problem persists, please contact your local reseller or service
center.
No image appears on-screen

-
-
-
Partial, scrolling or incorrectly displayed image

-
-
E Series User Manual
020-000287-01 Rev. 1 (01-2011)
Downloaded from ProjectorsManual.com Manuals
Make sure all the cables and power connections are correctly and
securely connected as described in the
Check if the projection lamp has been securely installed.
Make sure you have removed the lens cap and the projector is
switched ON.
Press AUTO on control panel or on remote control.
" "
If you are using a PC (for Windows 95, 98, 2000, XP, Windows 7):
Open the My Computer

"
double click on the
 Select the Settings
"
 Verify that your display resolution setting is lower than or equal to
WUXGA (1920 × 1200).
 Click on the Advanced Properties
"
not projecting the whole image, you will also need to change the
monitor display you are using. Refer to the following steps:
Verify the resolution setting is lower than or equal to WUXGA

(1920 × 1200).
Select the
"

Click on Show all devices
"

types under the SP box; choose the resolution mode you need
"
under the Models
"
Verify that the resolution setting of the monitor display is lower

than or equal to WUXGA (1920 × 1200).
icon, the
"
Display icon.
" "
tab.
"
Change button under the
"
. Next, select
"
box.
"
Section 5: Appendices
Installation section.
" "
Control Panel folder, and then
" "
button. If the projector is still
"
Monitor tab.
" "
Standard monitor
"
5-1