Led Indication Chart - Christie E SERIES User Manual

2.1.5 LED Indication Chart

The LED status indicators are located on the rear of the projector. Each LED
is defined below.
LAMP 1 LED



Lamp time has expired and lamp should be replaced.
(projector also begins to display the replace lamp OSD
message at startup).
Lamp 1 turn ON ok
Projector is switching to Lamp 1 (Lamp 2 is off)
(selected by OSD menu "Current Lamp": 1/ 2/ Both )
Lamp is off
LAMP 2 LED



Lamp time has expired and lamp should be replaced.
(projector also begins to display the replace lamp OSD
message at startup).
Lamp 2 turn ON ok
Projector is switching to Lamp 2 (Lamp 1 is off)
(selected by OSD menu "Current Lamp": 1/ 2/ Both )
Lamp is off
E Series User Manual
020-000287-01 Rev. 1 (01-2011)
Downloaded from ProjectorsManual.com Manuals
Projector State
Failed to strike lamp after 5 attempts (strike attempts
will stop).
Lamp has unexpectedly shut down (system goes
into cool down state).
Projector State
Failed to strike lamp after 5 attempts (strike attempts
will stop).
Lamp has unexpectedly shut down (system goes
into cool down state).
Section 2: Introduction
LED Status
Red (short blink)
Yellow (no blink)
Green (no blink)
Green (short blink)
Off
LED Status
Red (short blink)
Yellow (no blink)
Green (no blink)
Green (short blink)
Off
2-7