Table of Contents
Advertisement
A-61849/ISIS January 2016
The preview image will be oriented per the image processing
settings that were selected within the ISIS Driver (Automatic
Rotation). If the scanning application is rotating the image or
performing other image processing, the preview image will not have
scanning image processing applied.
- If scanning in duplex (front and back), then both images will be
displayed.
- If scanning in black and white, a black and white image will be
displayed.
- If scanning in color/grayscale, a color/grayscale image will be
displayed.
- If scanning in dual stream, a color/grayscale image will be
displayed.
- If scanning in black and white using VRS software, a grayscale
image will be displayed.
- Accepting the images: if you want to accept the image, touch
Accept on the Operator Control Panel or press the Start/
Resume button on the scanner. When Accept is selected, the
images shown in the scanner's preview will immediately be sent
to the scanning application and scanning will continue.
- Rescanning the page: if the page needs to be rescanned,
remove the top page(s) from the output tray and place the pages
back in the input elevator (be sure to correct any document
preparation issues). When the pages are ready to rescan, touch
Rescan on the Operator Control Panel. The preview images will
be discarded. If printing was not enabled, the scanner will
immediately start scanning. If printing was enabled, the scanner
will go to the Paused screen where you can choose to Omit
Printing on the next page scanned. You can then press the Start/
Resume button on the scanner to continue scanning.
• Pause Scanning - leave paper in path: scanning will stop
immediately (i.e., making no attempt to clear the paper path) but the
scanning application will be waiting for additional images (i.e., stops
the feeder). Image(s) of the multifed document will not be generated.
Clear any documents from the paper path prior to resuming the scan
session. Scanning may be resumed by pressing the Start/Pause
button on the scanner's Operator Control Panel. Scanning may be
stopped by pressing the Stop button on the scanner's Operator
Control Panel or via the scanning application.
• Pause Scanning - leave paper at exit: scanning will stop and the
last portion of the multifed document will be held at the transport's
exit, but the scanning application will be waiting for additional images
(i.e.,stops the feeder). Image(s) of the multifed document will not be
generated. Clear any documents from the paper path prior to
resuming the scan session. Scanning may be resumed by pressing
the Start/Pause button on the Operator Control Panel. Scanning may
be stopped by pressing the Stop button on the Operator Control
Panel or via the scanning application.
39
Advertisement
Table of Contents
