Table of Contents
Advertisement
A-61849/ISIS January 2016
Sensors — five sensors cover the width of the paper path. In order for
multifed documents to be detected correctly, they must pass under one
of these sensors.
• Left through Right: these controls allow you to select which of the
five sensor(s) you want to have turned on. For example, if you know
that the left side of the document has a "sticky" note on it, you can
turn off the left sensor.
• Ignore up to: ignores a multifeed anywhere on the document that is
less than the value entered. This option is useful when you have a
known multifeed situation that you want to allow, but do not want to
have the sensor off for the entire document (e.g., 3-inch "sticky"
note).
NOTES:
- This option is available when at least one sensor is set to On -
Ignore.
- This length applies to all sensors set to On - Ignore.
Length Detection ⎯ when enabled, you can select the maximum
length of the document that can be scanned without a multifeed being
detected. Length detection is used when scanning same-sized
documents to check for overlap. For example, if you are scanning A4
(8.5 x 11-inch) documents in portrait mode, enter a value of 28.57 cm
(11.25 inches) in the Max Length field. The maximum value is 35.56 cm
(13.99 inches).
Auto Set — when checked, automatically sets the maximum length
value to .50-inch greater than the length of the currently selected page
size.
Action When Detected — select what action you want the scanner to
take when a multifeed is detected. With all options, the condition will be
logged in the scanner.
• Stop Scanning: scanning will stop and control will return to the
scanning application (i.e., ends the job). Image(s) of the multifed
document will not be generated. Verify that the paper path has been
cleared and restart the scan session from the scanning application.
• Stop Scanning - generate image(s): scanning will stop and control
will return to the scanning application (i.e., ends the job). Image(s) of
the multifed document will be generated. Verify that the paper path
has been cleared and restart the scan session from the scanning
application.
• Stop Scanning - leave paper in path: scanning will stop
immediately (i.e., making no attempt to clear the paper path) and
control will return to the scanning application (i.e., ends the job).
Image(s) of the multifed document will not be generated. Clear any
documents from the paper path prior to restarting the scan session
from the scanning application.
37
Advertisement
Table of Contents
