GRAUPNER mx-16 HOTT Programming Manual page 161

GRAUBELE stop
#01 flt
RFC–Teach «nor mal
5.2V
2:22h P
... then this indicates that the Pupil signal has also been
lost, but the Trainer transfer switch is in the "Teacher"
position.
In either situation your first recourse should be to reduce
the distance between the two transmitters. If this does
not help, land the model immediately, and seek the
cause.
However, if both transmitters are operating with the re-
ceiving system switched off, then the "familiar" symbol
appears in the basic display of the Teacher transmitter
instead of the two symbols.
Resuming Trainer mode operations
If - for whatever reason - one or both transmitters are
switched off during a Trainer mode session, then the
screen displays the following query when the transmitter
or transmitters are switched on again:
TRAINER
Wireless Link
ACT INH
SET
Touch the central button of the right-hand touch-key
to confirm "ACT(ivate)", or alternatively wait for about
two seconds until the message disappears; the last link
you created with a Teacher or Pupil transmitter is now
restored.
However, if you select "INH(ibit)" using one of the arrow
buttons of the left or right-hand touch-key ...
0:00
0:00
»
HoTT
ACT
5.5V
... and confirm your choice by briefly pressing the cen-
SET
tral button of the right-hand touch-key, this resets
that transmitter to "normal" operation. In this case you
will have to repeat the binding process with a Teacher or
Pupil transmitter as and when required.
TRAINER
Wireless Link
INH
Program description: Trainer system 161