Installing The Ws 2000 Wireless Switch - Symbol WS 2000 System Installation Manual

16 WS 2000 System Installation Guide
• Do not install this equipment or work with its power circuits during thunderstorms or
weather conditions where power surges can exist.
• Verify that there is adequate ventilation around the devices and that ambient temperatures
meet equipment operation specifications.
• Verify uninterruptible power sources—install the socket nearby and easily accessible to the
equipment.
• For equipment that needs to be plugged in, position equipment near an easily accessible
socket-outlet.

3.3 Installing the WS 2000 Wireless Switch

3.3.1 Selecting a Site for Installation
The WS 2000 Wireless Switch can be installed on a flat surface, on a wall, or in a rack. In selecting
a site, the installer should verify that the location has access to:
• A grounded outlet—preferably one that has surge protection or is protected by a
uninterruptible power supply (UPS)
• The WAN connection for the switch (whether a modem, router, switch, or hub)
(The wireless switch comes with a 6 ft. (1.829 m) patch cable for this purpose, but the
installer is not required to use either that cable or stay within that distance.)
• The LAN connections for this switch (whether Access Port, switch, hub, or computer)
Ensure that this location meets optimal temperature and environmental requirements for the
operation of this device (see
3.3.2 Desk Mounting
The desk mount option uses rubber feet which allow the unit to sit on most flat surfaces. The four (4)
round rubber feet can be found in the WS 2000 Wireless Switch (main) box in a separate plastic bag.
1. Turn the switch upside down so that the side with the power connector is facing up.
2. Connect the power supply to the switch as shown in diagram.
Do not attach the power supply to the wall outlet until
installation of the switch is complete.
Section 2.2.1, WS 2000 Technical Specifications).