Symbol WS 2000 System Installation Manual page 25

3.4.2.2 Ceiling Mount Procedure
1. If required, loop a safety wire—with a diameter of at least 1.01 cm (.04 in.), but no more
than 0.158 cm (.0625 in.) —through the tie post and secure the loop.
2. If required, install and attach a security cable to the lock port.
3. Plug the Ethernet cable into the unit and to a switch with an 802.3af-compatible power
source.
4. Face the bottom of the T-bar with the back of the case.
5. Orient the case by its length and the length of the T-bar.
6. Rotate the case in place 45 degrees clockwise, or about 10 o'clock.
7. Push the back of the case onto the bottom of the T-bar.
8. Rotate the case 45 degrees counter-clockwise. The clips click as they fasten to the T-bar.
9. Verify the unit has power by observing the LEDs.
Installing the Branch Office Wireless System
2
3
1
25