Symbol WS 2000 System Installation Manual page 23

Hide thumbs Also See for WS 2000:

Table of Contents

2. Connect a CAT-5 cable to a compatible 802.3af power source and run the cable to the

installation site. Ensure that there is sufficient slack on the cable to perform the installation

steps.

3.4.1 Wall Mounting

Wall mounting requires hanging the AP 300 Access Port along its width or length using the pair of

slots on the bottom of the unit. The AP 300 can be mounted onto any plaster, wood, or cement wall

surface using the provided wall anchors, when necessary. The illustration shows a lengthwise mount.

3.4.1.1 Wall Mount Hardware

• Two Phillips pan head self-tapping screws

• Two wall anchors

• Safety wire (recommended) and security cable (optional)

In the event that the original mounting screws are lost, the following screws

can be used instead: (ANSI Standard) #6-18 x 0.875in. Type A or AB Self-

Tapping Screw, or (ANSI Standard Metric) M3.5 x 0.6 x 20mm Type D Self-

Tapping Screw

3.4.1.2 Wall Mount Procedure

1. Orient the case on the wall by its width or length.

Installing the Branch Office Wireless System

Table of Contents