Power Supply - Symbol WS 2000 System Installation Manual

The use of 5 GHz RLANs has varying restrictions of use; please refer to the Symbol Declaration of
Conformity (DoC) for details.
Operation of the AP 300 Access Port without regulatory approval is illegal.
FCC/EU RF Exposure Guidelines
Safety Information
The device complies with Internationally recognized standards covering Specific Absorption Rate (SAR) related to human
exposure to electromagnetic fields from radio devices. It is advisable to use the device only in the normal operating position.
Remote and Standalone Antenna Configurations
To comply with FCC RF exposure requirements, antennas that are mounted externally at remote locations or operating near
users at stand-alone desktop or similar configurations must operate with a minimum separation distance of 20 cm from all
persons.

Power Supply

The AP 300 Access Port is powered from a 802.3af compliant power source which is UL approved.
Radio Frequency Interference Requirements
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
Symbol Technologies Inc.
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
Tested to Comply
With FCC Standards
against harmful interference in a residential installation. This equipment generates, uses, and can
For Home or Office Use
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help.
Radio Transmitters (Part 15)
The AP 300 Access Port complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Configuring the WS 2000 Wireless Switch
43