Symbol WS 2000 System Installation Manual page 33

Hide thumbs Also See for WS 2000:

Table of Contents

2. Check to make sure that all the ports and WLAN1 are selected for this subnet. WLAN1

should automatically be included if the switch and the access port are communicating

properly. If WLAN1 is not present in the list, check:

• The power to the Access Port

• The connections between the switch and the access port

• The LEDs to make sure that lights are on and flashing

3. For this initial configuration, ensure that This interface is a DHCP Server is enabled. If

so, the switch sets the IP addresses automatically for the mobile devices. This value can be

changed at any time in the future. All other default settings are fine for the system test.

DHCP is a protocol that includes mechanisms for IP address allocation and delivery of host-

specific configuration parameters from a DHCP server to a host. Some of these parameters

are IP address, network mask, and gateway. The switch includes internal DHCP server and

client features, and the subnet's interface can use either capability.

4. Click the Apply button if any changes were made.

Configuring the WS 2000 Wireless Switch

Table of Contents