Installing The Ap 300 Access Port - Symbol WS 2000 System Installation Manual

22 WS 2000 System Installation Guide
The WAN port is capable of hooking up to a DSL or cable modem, or to any Layer 2/3 network device.
Plug devices into RJ-45 ports using standard CAT-5 patch cables.
The power LED flashes during startup and remains lit during normal operation.
Each Ethernet port has two LEDs. The LED on the left hand side of the port indicates whether the port
is transmitting at 10 Mbits/sec. or 100 Mbits/sec. The light is off when transmitting at 10 Mbit/sec.
The light is on when transmitting at 100 Mbits/sec.
The LED on the right side indicates an Ethernet link or activity on that port. This light is on solidly when
a link to a device is made. The light flashes when traffic is being transferred over the line.
The four ports that have PoE capabilities also have a PoE LED. A green light indicates that 48 volts is
being delivered to the power device connected to that port. A red light indicates that the power device
on the port is faulty. Once set to red, the light will remain red until a non-faulty device is installed. If
a non-power device is connected to the port, the PoE light will remain off.

3.4 Installing the AP 300 Access Port

The AP 300 Access Port mounts either on a wall with wide-shoulder screws or on a suspended ceiling
T-bar. This unit is not designed for mounting on a desk.
To prepare for installation, perform the following steps:
1. Review site survey and network analysis reports to determine the location and mounting
position for the AP 300 Access Port.
10/100 Link/Activity
PoE