Symbol WS 2000 System Installation Manual page 24

24 WS 2000 System Installation Guide
2. Using the arrows on one edge of the case as guides, move the edge to the midline of the
mounting area and mark points on the midline for the screws.
3. At each point, drill a hole in the wall, insert an anchor, screw into the anchor the wall
mounting screw and stop when there is 1mm between the screw head and the wall.
When pre-drilling a hole the recommended hole size is 2.8mm (0.11in.)
if the screws are going directly into the wall and 6mm (0.23in.) if the
provided wall anchors are being used.
4. If required, loop a safety wire—with a diameter of at least .101 cm (.04 in.) but no more than
0.158 cm (.0625 in.)—around the tie point and secure the loop.
5. If required, install and attach a security cable to the unit's lock port.
6. Attach the Ethernet cable to the unit and to a switch with an 802.3af-compatible power
source.
7. Place the middle of each of the case's mount slots over the screw heads.
8. Slide the case down along the mounting surface to hang the mount slots on the screw
heads.
9. Verify the unit has power by observing that the LEDs are lit or flashing.
3.4.2 Suspended Ceiling T-Bar Mount
Ceiling mount requires holding the AP 300 Access Port up against a T-bar of a suspended ceiling grid
and twisting the case onto the T-bar.
3.4.2.1 Ceiling Mount Hardware
• Safety wire (recommended) and security cable (optional)
5
6
4