Where To Go From Here - Symbol WS 2000 System Installation Manual

1. Go to the mobile unit and ensure that it is set up as a DHCP client.
2. Set the mobile unit for WEP 128 encryption and set the same key as the one that was
entered in the WEP Key Settings dialog. It may be necessary to reboot the mobile unit after
changing the settings.
3. Open a Web browser and type the IP address: 192.168.0.1.
The WS 2000 Switch Management screen should appear. If not, go back to the wired system
used to configure the switch and see if the mobile device appears in the MU Stats screen
(Status & Statistics --> MU Stats). If it does not appear on the MU Stats screen, recheck
the network and WEP settings on the mobile device.
4. In the Web browser, enter a URL for a site (such as www.symbol.com) on the WAN. If the
site does not appear, go to the WAN Stats screen (Status & Statistics --> WAN Stats) to
review the status of the WAN connection.

Where to Go from Here?

Once full connectivity has been verified, the switch can be fully configured to meet the needs of the
organization. The Online System Reference has detailed information about how to configure the WS
2000 Wireless Switch. In addition, two case studies are provided on the CD for specific installation
examples. These case studies describe the environment, the desired features, and the configuration
selections that were made in two different scenarios.
• Case 1: Small Retail Store
(with handheld terminals, wireless printers, wired POS, secured access to in-store server,
and public access to WAN)
• Case 2: Small Branch Office
(with 3 WAN IP addresses, VPN passthrough, RADIUS server, and full-access between
subnets)
Configuring the WS 2000 Wireless Switch
41