Table of Contents
Advertisement
SERVICE WORK ON THE CHASSIS
Checking the rubber grip
10.39
Additionally securing the rubber grip
10.40
Adjusting the basic position of the clutch lever
10.41
Checking the fluid level of the hydraulic clutch
10.42
Info
The fluid level rises with increasing wear of the clutch facing discs.
–
Check the rubber grips on the handlebar for damage and wear and to ensure they
are firmly seated.
»
If a rubber grip is damaged, worn or loose:
–
Change and secure the rubber grip.
Rubber grip adhesive (00062030051) (
401197-01
Preliminary work
–
Check the rubber grip. (
Main work
–
Secure the rubber grip at two points using the securing wire.
Securing wire (54812016000)
Wire twister forceps (U6907854)
The twisted wire ends face away from the hands and are bent toward the rub-
ber grip.
401198-01
–
Adjust the basic position of the clutch lever to your hand size by turning adjusting
screw
.
1
Info
Turn the adjusting screw clockwise to increase the distance between the
clutch lever and the handlebar.
Turn the adjusting screw counterclockwise to decrease the distance between
the clutch lever and the handlebar.
The range of adjustment is limited.
Turn the adjusting screw by hand only, and do not apply force.
B01073-10
Do not make any adjustments while riding!
–
Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.
–
Check the fluid level in viewer
»
If the fluid has dropped below marking
–
Correct the fluid level of the hydraulic clutch. (
B01081-10
p. 106)
p. 56)
.
1
in the viewer:
A
56
p. 57)
Advertisement
Table of Contents
