Table of Contents
Advertisement
BRAKES
Checking the free travel of the hand brake lever
11.1
Warning
Danger of accidents Brake system failure.
–
If there is no free travel on the hand brake lever, pressure builds up in the front brake circuit. The front brake can fail due
to overheating. Adjust free travel on hand brake lever according to specifications.
Adjusting the free travel of the handbrake lever
11.2
Checking the brake discs
11.3
Warning
Danger of accidents Reduced braking efficiency due to worn brake disc(s).
–
Change the worn brake disc(s) without delay. (Your authorized KTM workshop will be glad to help.)
–
Push the hand brake to the handlebar and check free travel
Free travel of hand brake lever
»
If the free travel does not meet specifications:
–
Adjust the free travel of the handbrake lever. (
B01086-10
–
Check the free travel of the hand brake lever. (
–
Adjust the free travel of the handbrake lever with adjustment screw
Info
Turn the adjustment screw clockwise to reduce free travel. The pressure
point moves away from the handlebar.
Turn the adjustment screw counterclockwise to increase free travel. The
pressure point moves towards the handlebar.
The range of adjustment is limited.
Turn the adjusting screw by hand only, and do not apply force.
B01085-10
Do not make any adjustments while riding!
–
Check the thickness of the front and rear brake discs at several places on the disk
to see if it conforms to measurement
Info
Wear reduces the thickness of the brake disc around the area used by the
brake linings.
Brake discs - wear limit
Front
400257-10
Rear
»
If the brake disc thickness is less than the specified value:
–
Change the brake disc.
–
Check the front and rear brake discs for damage, cracking and deformation.
»
If the brake disc shows signs of damage, cracking, or deformation:
–
Change the brake disc.
.
A
≥ 3 mm (≥ 0.12 in)
p. 59)
p. 59)
.
A
2.5 mm (0.098 in)
3.5 mm (0.138 in)
59
.
1
Advertisement
Table of Contents
