Electrical System; Removing The Battery; Installing The Battery - KTM Freeride 350 Owner's Manual

ELECTRICAL SYSTEM

Removing the battery

x
13.1
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep the battery away from sparks or open flames. Charge only in well-ventilated areas.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a physician.

Installing the battery

x
13.2
–
Switch off all power consumers and switch off the engine.
–
Remove screw
–
Take off fastening plate
B01102-10
–
Take the battery out of the battery compartment.
–
Disconnect negative cable
–
Pull back the positive terminal cover
the battery.
B01103-10
–
Connect the positive cable.
Guideline
Screw, battery terminal
–
Attach negative cable.
Guideline
Screw, battery terminal
Battery (YTX4L-BS) (
Info
Contact disk
with the claws facing down.
–
Slide positive terminal cover
B01104-10
.
1
.
2
of the battery.
3
and disconnect the positive (plus) cable of
4
M5
M5
p. 98)
must be mounted between screw
A
over the positive terminal.
3
72
2.5 Nm
(1.84 lbf ft)
2.5 Nm
(1.84 lbf ft)
and cable socket
1 2