Table of Contents
Advertisement
BRAKES
Warning
Danger of accidents Reduced braking efficiency due to use of non-approved brake linings.
–
Brake linings available from accessory suppliers are often not tested and approved for use on KTM vehicles. The construc-
tion and friction factor of the brake linings and therefore the brake power can differ considerably from the original KTM
brake linings. If brake linings are used that differ from the originals, there is no guarantee that they comply with the origi-
nal license. The vehicle no longer corresponds to the condition at delivery, and the warranty is no longer valid.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Never use DOT 5 brake fluid! It is silicone-based and purple in color. Oil seals and brake lines are not designed for DOT 5
brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint!
Use only clean brake fluid from a sealed container.
–
Stand the vehicle upright.
–
Remove screws
–
Remove cover with membrane
–
Press the brake piston back to its basic position and make sure that no brake fluid
overflows from the brake fluid reservoir.
B01099-10
–
Take off spring connector
–
Take off retainer spring
–
Clean the brake caliper.
B01100-10
–
Position the brake linings.
Info
Always change the brake linings in pairs.
B01101-01
–
Position retaining spring
–
Mount bolt
–
Mount spring connector
Info
To make it easier to mount the bolt, push the retaining spring down.
Make sure the retaining spring is seated correctly.
–
Operate the foot brake lever repeatedly until the brake linings are in contact with
the brake disc and there is a pressure point.
B01100-10
.
1
.
2
and remove bolt
3
and remove the brake linings.
5
.
5
.
4
.
3
.
4
66
Advertisement
Table of Contents
