Table of Contents
Advertisement
BRAKES
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Never use DOT 5 brake fluid! It is silicone-based and purple in color. Oil seals and brake lines are not designed for DOT 5
brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint!
Use only clean brake fluid from a sealed container.
–
Move the brake fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
B01088-11
–
Remove screws
–
Press back the brake linings with a light lateral tilting of the brake caliper on the
brake disc. Carefully pull the brake caliper backwards from the brake disc.
–
Press the brake piston back to its basic position and make sure that no brake fluid
overflows from the brake fluid reservoir.
B01091-10
–
Remove cotter pin
–
Remove bolt
–
Take off retainer spring
–
Clean the brake caliper.
–
Position the brake linings.
Info
Always change the brake linings in pairs.
B01092-10
–
Position retaining spring
–
Mount bolt
–
Mount spring connector
Info
To make it easier to mount the bolt, push the retaining spring down.
Make sure the retaining spring is seated correctly.
–
Position the brake caliper. Mount screws
–
Operate the hand brake lever repeatedly until the brake linings are in contact with
the brake disc and there is a pressure point. Fix the hand brake lever in the acti-
vated position.
The brake caliper straightens.
–
Tighten screws
Guideline
Screw, front brake caliper
B01091-10
–
Remove the fixation of the hand brake lever.
.
1
with membrane
.
2
3
and spacers.
4
.
5
.
6
and remove the brake linings.
7
.
7
.
6
.
5
.
4
M8
with the spacers but do not tighten yet.
4
25 Nm
Loctite
(18.4 lbf ft)
62
®
243™
Advertisement
Table of Contents
