Checking The Headlight Setting - KTM 125 Duke Owner's Manual

ELECTRICAL SYSTEM

Checking the headlight setting

13.7
A 0 0 A
–
Fold the headlight mask up.
–
Mount and tighten screws
Guideline
Screw, headlight mask
–
Mount expanding rivets
–
Check that the lighting is functioning properly.
B00759-10
–
Position the vehicle upright on a horizontal surface in front of a light wall and make a
mark at the height of the center of the low beam headlight.
–
Make another mark at a distance
Guideline
Distance
B 0 0 B

–
Position the vehicle vertically at a distance
beam.
Guideline
400726-10
Distance

–
The rider, with luggage and passenger if applicable, now mounts the motorcycle.
–
Check the headlight setting.
The light-dark boundary must lie exactly on the lower mark when the motorcycle is
ready to operate with the rider mounted along with any luggage and a passenger if
applicable.
.

M6
on both sides.

under the first mark.

5 cm (2 in)
in front of the wall and switch on the low

5 m (16 ft)
106
14 Nm
(10.3 lbf ft)